Edge Banding Router Bits 2 pc Set | EAGLE AMERICA
5 of 5 Stars (1 review)
EAGLE AMERICA Edge Banding Router Bits 2 Piece Set puts hardwood edges on your plywood, particle boards or MDF stock.
Here is a simple way for you to make your own hardwood edge banding to finish off those plywood or MDF panels and shelves from 1/2" to 1" thick. Simply set the male groovers in your router table so that the center point of the bit is centered on the stock and make the cut. Now using the female grooves in your router table, set the height of the bit so that the center point of the bit matches the center point of the panel stock and then cut out the hardwood stock material. Glue the two pieces together and flush trim the edges if necessary. The 90 degree bit sets (A) also makes horizontal v-grooves or double sided chamfers. The 60° bit sets (B) feature a tongue and groove design for a larger gluing surface. All bits two flute, carbide tipped with bearing guides. Made in the USAThe Eagle America Difference
The Eagle America Brand was created for the professional woodworker who needs a serious router bit with an exceptional cut, extremely high durability and longevity.
Lifetime Warranty against defects in workmanship and materials.
Precision ground carbide to +/- .005 tolerances and Balanced to speeds in excess of 25,000 RPM for true, chatter-free running.
High hook and relief shear angles with wide open gullets for easy chip ejection.
Single-piece, SOLID STEEL Bodies, not just a mere sand casting.
Finest Micrograin Carbide up to C-4 grade with tips up to 1/8" thick for longer life.
Shielded, high-RPM-rated bearings have special lubricants for mar-free routing.
Carbide honed with a 600 grit diamond wheel to a razor sharp mirror finish edge.
Steel is heat treated up to 3 times, and tested up to 45 RC hardness to guarantee against breakage.
Precision-ground shanks.
5 StarsProduct Options
You May Also Like
-
$29.95$22.00
